在G5100A的韌體版本1.6(含)前只有關閉系統警告音，而不能關閉操作時的聲音。只有韌體版本1.7以上才可以分別關閉系統警告音及操作音。以下是音效開/關步驟。

1. Press [Utility] and choose “System”.
2. Press soft-key [Sound] to on/off the sound of operation keys or press [Beep] to on/ off the warning beep.
3. Press [DONE] back to normal operation.

G5100A waveform generator provides the capability of outputting a specified pattern of up to 256k points in 16-bit resolution. Similar to arbitrary waveforms, pattern output provides five built-in patterns and up to four user-defined patterns that are stored in non-volatile memory. The built-in patterns are exponential-rise, exponential-fall, negative-ramp, sinc, and cardiac. The default pattern output is an exponential-rise wave.

You may use the Wavepatt®, waveform and pattern editor to create the patterns you want or import the waveforms from the oscilloscope that you captured previously and follow below steps to set up pattern output.

1. Press the Utility button to enter the utility menu.
   
2. Press the softkey under [PATT MODE] to enter the PATTERN menu.
   
   
   
3. Press the softkey under [Fclk/Perd] to toggle between [Fclk] (frequency) and [Perd] (period).
   
   
   
4. Press the softkey under [Start Addr]/ [End Addr] for setting the start /end point of the pattern to output. Use the knob with the cursor keys to change the value. Or use the numeric keypad to enter a new value and then press [Enter] to finish the entry or the press [Cancel] to withdraw the changes.
       
   
   
5. Press the [Select wform] to enter selection menu:
   a. Press [Built In] and choose the desired pattern from the five built-ins by pressing the corresponding softkey.
   b. Press [Saved Wform] and choose the desired user-defined pattern by pressing the corresponding softkey.
   c. One may delete a user-defined pattern by pressing the softkey under Delete Store and choose the pattern to delete by pressing the corresponding softkey.
   
   
   
6. Press the [Output Setting] and then press [RPT.] to toggle between ON and OFF to enable/disable repeating output of the pattern.
   
   
   
7. To configure the trigger setting, press [Trig Setup] to enter the trigger setup menu:
   a. To specify the trigger source, press the softkey under Src and then select among Ext (external) and Man (manual).
   b. If manual trigger is selected, you may configure the trigger out signal by pressing the softkey under Trig Out and then select among OFF, rising-edge trigger and falling-edge trigger.
   c. If external source is selected, you may press the softkey under Slope to toggle between rising edge trigger and falling edge trigger.
   d. Press the softkey under DONE to finish the trigger setting.
   
   
   
8. After completed above setting. Press function key [Output] to generate the pattern out. The pattern would be outputted once only if the setting of [RPT.] is OFF in the [Output Setting].